top of page




HSS Eclipse – The allround HSS Solution


Due to a sophisticated PVD coating for wear protection which achieves a very low friction coefficient, the Eclipse saw blade is a cost efficient solution for cutting structural and non-alloy tool steel thin walled tubes.

When cutting tubes and profiles on manual and semi-automatic sawing machines, Eclipse allows a higher cutting speed than a steam treated saw blade. It can even be used for cutting thin walled tubes on automatic machines.

Eclipse is also very suitable for cutting stainless steel tubes and profiles.

Advantages compared to steam treated:

  • Higher blade life

  • Increased uptime

  • Lower cost per cut

  • Little to no side pick-up

  • Higher production output

  • Ideal for cutting both structural- and stainless steel


  • All structural steel and non-alloy steel thin walled tubes

  • Tensile strength up to 600 N/mm2

  • Steel – Suggested cutting speed: 60 – 120 m/min

  • Austenitic stainless steel (300 series) – Suggested cutting speed: 30 – 50 m/min – Blade life:≈1m2

  • Ferritic w/o Ti (409 & 412) – Suggested cutting speed: 220 – 260 m/min – blade life: ≈1m2

  • Ferritic with Ti (441) – Suggested cutting speed: 60 – 120 m/min

  • Feed: 0,03 – 0,09 mm/tooth

  • Machines: manual, semi-automatic, automatic, flying cut-off applications

1277717989_Logo kinkelder scherp 1.jpg
bottom of page